[realtreegrizzly]

Noticed my glove box lid doesn't fit to good latches tight where the retainer is but both upper sides are bowed out. Planning on taking a heat gun getting it good and warm and trying to bow it out in the middle let it cool and maybe it will stay. Any one else have a loose lid. Lol

 

[rinconruss]

Mine is also bowed

 

[qualt]

Mine has a terrible fit too.

 

[Springer]

Me too

 

[Thunderstix]

It is supposed to be like that

 

[DG Rider]

It is supposed to be like that

Why?
And if so, why did Honda bother putting a rubber seal around it?

 

[Thunderstix]

I am just joking . I figured if everyones is like that, maybe they are supposed to be a crappy fit LOL.

 

[DG Rider]

I am just joking . I figured if everyones is like that, maybe they are supposed to be a crappy fit LOL.

Ah...i didn't realize...

 

[White Park]

My lid does not fit very good either. Let me know how that heat gun job turns out.

 

[bootwayout]

Mine was terrible as well, did the heat gun thing, much better now

 

[realtreegrizzly]

I actually removed my lid and put it on the wife's ironing board applied a little heat got it good and warn just the top though held it where it was bowed a little across the top run some cold water across it to cool it fast BINGO fits like it was intended to

 

[Dick]

realtreegrizzly have you spray yours with a hose yet, just wondering if it was water tight now?
Mine doesn't look bad but a get a little water in the compartment when I spray it.

 

[realtreegrizzly]

No water yet I just read my last post sounds like I used the iron to heat it. I used the hair dryer just thought the ironing board would be a good place to keep the heat from damaging anything else

 

[Dick]

I was planning on using the heat gun, might be dangerous to your health using your wife's iron to melt plastic.

 

[White Park]

With all that success you guys have had using heat mine will see the heat gun tomorrow evening. I don't like things that don't fit proper. Thanks for your help. This has bothered me since I picked up my Pioneer.

 

[realtreegrizzly]

Note to everyone using a heat gun DO NOT hold your heat gun to close to the lid or in one place to long as it will melt you want just enough heat to make it give just enough that when it cools it will fit even heat all across the top only not at the bottom

 

[rich450es]

Note to everyone using a heat gun DO NOT hold your heat gun to close to the lid or in one place to long as it will melt you want just enough heat to make it give just enough that when it cools it will fit even heat all across the top only not at the bottom

or it will look like this

 

[ccbrett]

Mine bows a little I'll try it. Don't think it's meant to be water proof thought the glove box is equipped with drain holes.

 

[scott]

Mine does it a little. But i have had it out in heavy rain and no water got in it.

 

[hog wild]

mine just started to bo as well not happy