Honda Pioneer Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
903 Posts
Discussion Starter · #1 ·
How much load have you had on the KFI winch mount?

There are some who don't like the fact that "only" a few welds hold the front bumper ( and thus, the winch mount itself ) on. I admit i am concerned about this, even though i did buy a KFI. After screwing around With a Super ATV winch mount, I'm ready to sell it and mount the KFI.

Any thoughts?
 

·
Registered
Joined
·
1,395 Posts
I'm okay with it. I did a test pull with the XT 40. I was dragging the machine with the brakes slammed on. I think it will be adequate.

Long term.... Guess we will see.
 

·
Registered
Joined
·
131 Posts
I'm interested to hear replies to this also. I thought things look a little weak for a 4k lb winch.

Moose, I'm guessing your test was on frozen ground with snow?

I would like to see how they hold up to one buried in mud or up a steep rock.
 

·
Registered
Joined
·
1,395 Posts
I'm interested to hear replies to this also. I thought things look a little weak for a 4k lb winch.

Moose, I'm guessing your test was on frozen ground with snow?

I would like to see how they hold up to one buried in mud or up a steep rock.
Yes Farmer. I made it as difficult as I could, but we don't have mud for about 5ft of permafrost. :)
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top