Honda Pioneer Forum banner
1 - 8 of 8 Posts

·
Premium Member
Joined
·
1,602 Posts
They look good! What did you cut them with?
 

·
Registered
Joined
·
252 Posts
Very nice. Do you feel like making some A-arm guards to re sell?
 

·
Premium Member
Joined
·
1,602 Posts
I thought you were going to say computerized plasma cutter.
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #7 ·
The aluminum is .125 as far as cost not sure got it from a buddy that works wth it all the time and always has scrap. You would only need a 4' x 4' pc.to do both pieces. I will post picture of them on machine when the weather warm up which will probably be around april.
 

·
Registered
Joined
·
66 Posts
The aluminum is .125 as far as cost not sure got it from a buddy that works wth it all the time and always has scrap. You would only need a 4' x 4' pc.to do both pieces. I will post picture of them on machine when the weather warm up which will probably be around april.
Thanks. You did a nice looking job. I wish I had access to a CNC mill. I ran one for years I could cut them out 8 at a time.
 
1 - 8 of 8 Posts
Top